LR3/Disco 3
Installer rear lower arm rear bush
204-540/3
Removal
NOTE:
The bushings must be replaced in pairs, LH and RH sides.
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the wheels and tires.
3 .
Remove the LH lower arm. For additional information, refer to
Lower Arm (64.35.54)
(Section 204-
02)
4 .
Remove the RH lower arm.
5 .
Note the position of the bushing in relation to the lower arm.
6 .
CAUTION: The bush flanges need to be removed to allow bush removal.
NOTE:
Take note of the fitted position of the bush.
Using a suitable tool, bend over the bush flanges.
7 .
Using a hacksaw, remove the flange from the bushing, making sure the upper arm is not damaged.
8 .
Using the special tools, remove and discard the lower arm rear bushings.