LR3/Disco 3
Installation
9 .
Using the special tool, remove the lower arm ball joint.
Support the wheel knuckle to give access to the lower ball joint.
Remove and discard the snap ring.
1 .
CAUTION: If the push in force is less than 17 kN the wheel knuckle must be replaced.
CAUTION: Make sure rthe ball joint in installed from the chamfered side of the wheel knuckle.
Using the special tool, install the lower arm ball joint.
Install the snap ring.
2 .
Using the special tools, install the halfshaft in the wheel hub.
3 .
CAUTION: Ensure the ball joint seal is not damaged. A damaged seal will lead to the premature