LR3/Disco 3
Air Suspension Control Module (60.50.04)
Removal
Installation
1 .
Driver side: Remove the cowl side trim panel. For additional information, refer to
Cowl Side Trim
Panel (76.13.27)
(Section 501-05)
2 .
Remove the closing trim panel.
Release the clip.
Remove the 2 screws.
Disconnect the electrical connector.
3 .
Remove the air suspension control module.
Disconnect the 4 electrical connectors.
Remove the bolt.
Release from the 2 clips.
1 .
Install the air suspension control module.
Secure with the clips.
Connect the electrical connectors.
Tighten the bolt to 9 Nm (7 lb.ft).