LR3/Disco 3
Suspension Height Sensor (60.36.01)
Removal
NOTE:
Installation
The right hand sensor has a black colored lever and the left hand sensor has a white colored lever.
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the wheel and tire.
3 .
CAUTION: Do not use excessive force to disconnect the height sensor link.
Remove the suspension height sensor.
Disconnect the height sensor link arm.
Disconnect the electrical connector.
Remove the 2 Torx screws.
1 .
To install, reverse the removal procedure.
Tighten the screws to 2.2 Nm (1.5 lb.ft).
2 .
CAUTION: Height suspension calibration, using T4, must always be carried out if the
suspension height sensor fixings are removed.
Use T4 to re-calibrate the suspension system.