LR3/Disco 3
FRONT DRIVE SHAFT
The front drive shaft is constructed from 1.7 mm wall tubular steel. A CV joint is attached to each end of the drive shaft
(see 'Halfshaft Joint' section for more information on CV joints). The shaft has an overall nominal length of 713 mm.
Each CV joint has six holes, which allow for attachment to the input flange of the front differential and the front output
flange of the transfer box. The CV joints are secured to the front differential and transfer box with six Torx head adhesive
retained bolts.
Three compression link washers are fitted under each pair of bolts. The washers are required to prevent compression of
the CV joints attachment flange.
A shroud is pressed over the CV joint. The shroud seals to the joint body using an internal gasket and to the front output
flange of the transfer box using an end cap and internal gasket. This prevents the ingress of dirt and moisture. The CV
joints allow for movement of the drive shaft caused by small movements in the transmission and transfer box mountings.
REAR DRIVE SHAFT ASSEMBLY
Item Part Number
Description
1
-
CV joint
2
-
Front drive shaft
Item Part Number
Description
1
-
CV joints