LR3/Disco 3
Installation
Using a transmission jack support the front differential case.
8 .
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
Disconnect the breather line.
Release the clip.
9 .
Remove the front differential case.
Remove and discard the three differential mounting bolts.
Remove the differential front mounting bolt.
With assistance, manoeuvre and lower the front differential case.
1 .
Install the front differential case.
With assistance, raise and manoeuvre the front differential case.
2 .
With assistance, align and secure the front differential case.
Connect the breather line.
Tighten the M14 bolt to 105 Nm (77 lb.ft).
Tighten the M12 bolts to 80 Nm, plus a further 60 degrees.
3 .
Attach the driveshaft to the front axle drive flange.
Tighten the new Torx bolts to 45 Nm (33 lb.ft), then a further 90 degrees.
