LR3/Disco 3
Outer Constant Velocity (CV) Joint Boot (47.10.03)
Removal
Installation
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the wheel and tire.
3 .
Remove the halfshaft. For additional information, refer to
Halfshaft LH (47.10.01)
(Section 205-04)
4 .
Clamp the halfshaft in a vise.
5 .
Remove and discard the CV joint boot retaining clamps.
6 .
Slide the CV joint boot along the halfshaft to gain access to the joint.
7 .
Using a drift against the inner part of the CV joint, remove the CV joint from the halfshaft.
Remove and discard the snap ring.
8 .
Remove the outer CV joint boot.
1 .
Clean the components.