LR3/Disco 3
Installation
1 .
WARNING: Do not use compressed air to clean brake components. Dust from friction materials
can be harmful if inhaled.
Clean the caliper housing and anchor plate using brake cleaning fluid.
2 .
Inspect the caliper piston and slide pin seals for damage.
3 .
Position a bleed jar containing a small quantity of approved brake fluid. Connect the bleed tube to
the bleed screw and loosen the screw.
4 .
Press the piston into the caliper housing.
Tighten the bleed screw to 14 Nm (10 lb.ft).
5 .
Disconnect the bleed tube and remove the jar.
6 .
Install the brake pads.
Install the 2 clips.
7 .
Rotate the brake caliper downwards.
Tighten the bolt to 35 Nm (26 lb.ft).
8 .
Connect the brake pad wear indicator sensor.
9 .
Repeat the above procedure for the other side.
10 .
Install the wheels and tires.
Tighten the wheel nuts to 140 Nm (103 lb.ft).
11 .
Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top up
with brake fluid if necessary.