LR3/Disco 3
Vehicles with manual transmission
All vehicles
Vehicles with manual transmission
1 .
Install the brake booster.
Tighten the nuts to 23 Nm (17 lb.ft).
2 .
Install the brake master cylinder.
Tighten the nuts to 26 Nm (19 lb.ft).
3 .
Connect the brake booster vacuum hose.
1 .
Connect the clutch master cylinder supply line.
1 .
Connect the low brake fluid warning indicator switch electrical connector.
2 .
Install the brake tubes.
Tighten the M12 brake pipe unions to 16 Nm (12 lb.ft).
Tighten the M14 brake pipe unions to 18 Nm (13 lb.ft).
3 .
Install the inner plenum base. For additional information, refer to
Auxiliary Battery Tray (76.10.31)
(Section 414-01)
4 .
Install the brake booster push rod clevis pin.
Install a new retaining clip.
5 .
Install the brake pedal buffer.
Tighten the bolts to 10 Nm (7 lb.ft).
Secure the wiring harness clip.
6 .
Install the instrument panel access panel.
Secure the 2 screws.
7 .
Bleed the brake system using T4. For additional information, refer to
Brake System Pressure
Bleeding (70.25.02)
(Section 206-00)
8 .
Install the closing trim panel.
Connect the electrical connector.
Secure the clip.
Tighten the screws.
1 .
Bleed the clutch system. For additional information, refer to
Clutch System Bleeding
(Section 308-