LR3/Disco 3
Brake Vacuum Pump - 4.0L/4.4L (70.50.19)
Removal
Installation
Published : Jul 21, 2004
1 .
CAUTION: Always plug any open connections to prevent contamination.
Remove the brake vacuum pump.
Release and disconnect the electrical connector.
Disconnect the vacuum line.
Remove the 2 nuts.
2 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the 2 rubber insulators.
1 .
To install, reverse the removal procedure.
Tighten the nuts to 5 Nm (4 lb.ft).