LR3/Disco 3
NOTE :
Make sure the ABS module locating grommet is correctly seated in the bracket before installing the
ABS module.
NOTE :
Make sure the ABS module locating pin is correcly located in the grommet, and the 2 front isolators
are fully seated in the bracket slots.
Install the ABS module.
Tighten the 2 ABS module retaining nuts to 8 Nm (6 lb.ft).
Remove the blanking caps from the ports.
Tighten the two M10 and three M12 brake tube unions to 15 Nm (11 lb.ft).
Tighten the M14 brake tube union to 17 Nm (13 lb.ft).
Connect the electrical connector.
Remove the ABS module from the mounting bracket.
2 .
Using T4, bleed the braking system. For additional information, refer to
Brake System Pressure
Bleeding (70.25.02)
(Section 206-00)
3 .
Install the cover.
4 .
If a new ABS module has been installed, interrogate the ABS system using T4.