LR3/Disco 3
Installation
6 .
Remove the wheel speed sensor.
Disconnect the electrical connector.
Release the wiring harness from the 5 clips.
1 .
Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
2 .
NOTE :
Make sure the electrical connector retaining clip is attached to the body wiring harness.
Install the wheel speed sensor.
Connect the electrical connector.
Attach the wiring harness to the 5 clips.
Tighten the bolt to 9 Nm (7 lb.ft).
3 .
Secure the brake caliper and anchor plate to the wheel knuckle.
Tighten the bolts to 275 Nm (203 lb.ft).
4 .
Secure the brake hose retaining bracket to the wheel knuckle.
Tighten the bolt to 25 Nm (18 lb.ft).
5 .
Install the fender splash shield. For additional information, refer to
Fender Splash Shield (76.10.48)
(Section 501-02)