LR3/Disco 3
Power Steering System Filling and Bleeding
1 . Check the power steering fluid level.
2 .
Remove the filler cap and fill to the MAX level mark.
3 . Start the engine and allow to run for 10 seconds, stop the engine.
4 .
Start the engine and turn steering fully lock to lock, stop the engine.
5 . Start and run the engine for 2 minutes, turn the steering fully lock to lock.
Published : May 24, 2004
CAUTION: Fluid must always be present in the reservoir during bleeding.
Install the reservoir filler cap.
Check the power steering fluid, if aerated, wait until fluid is free from bubbles then top-up reservoir to UPPER
level mark with recommended fluid.
CAUTION: Do not hold steering on full lock for longer than 10 seconds.
Check and top-up power steering fluid level.
Check and top-up power steering fluid level.
