LR3/Disco 3
Adapter, power steering pressure test
211-325 (LRT-57-042)
1 . Disconnect the battery ground cable.
Specifications
2 . Remove the engine cover.
Engine Cover - 2.7L Diesel (12.30.50)
3 . Siphon the fluid from the power steering reservoir.
4 . Position an absorbent cloth to collect fluid spillage.
5 .
NOTE :
NOTE :
Disconnect the power steering high-pressure pipe union.
6 . Install the special tools to the power steering high-pressure port.
7 . Install the special tool to the high-pressure union.
Remove the filler cap.
Install the filler cap.
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces
and connections are clean. Plug open connections to prevent contamination.
Some fluid spillage is inevitable during this operation.
Care must be taken to avoid contamination of the drive belt.
Remove the bolt.
Remove and discard the 2 sealing washers.
Position a container to collect the fluid.
Install the O-ring seal.
Tie the pressure gauge aside under the hood.
Install the O-ring seals.
Connect the special tool line, to the special tool valve block assembly.
