LR3/Disco 3
Installation
1 .
With assistance, install the steering gear.
Clean the component mating faces.
Tighten the bolts to 175 Nm (129 lb.ft).
2 .
NOTE :
Do not install the support bracket bolt until the steering gear connections are tightened.
Install the steering gear high pressure line.
3 .
NOTE :
Lubricate the seals with clean power steering fluid.
Connect the steering gear pressure lines.
Clean the component mating faces.
Install new O-ring seals.
4 .
Install the power steering line support bracket.
Tighten the bolt to 10 Nm (7 lb.ft).
5 .
Connect the tie-rod end ball joints.
Install new nuts and tighten to 70 Nm (52 lb.ft).
6 .
Connect the universal joint to the steering gear.
Install new patchlock bolt and tighten to 25 Nm (18 lb.ft).
7 .
Install the radiator access panel.
Install the 4 bolts and tighten to 10 Nm (7 lb.ft).
8 .
Install the front LH splash shield.
9 .
Install the front RH splash shield.
10 .
Install the front wheels and tires.
11 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-