LR3/Disco 3
9 .
Release both tie-rod end ball joints.
Loosen both tie rod end ball joint nuts.
Use the special tool.
Remove the 2 nuts.
10 .
CAUTION: Always plug any open connections to prevent contamination.
Disconnect the high pressure line from the power steering pump.
Disconnect the banjo bolt.
Allow the fluid to drain into a container.
Remove and discard the seals.
11 .
CAUTION: Always plug any open connections to prevent contamination.
NOTE :
Under no circumstances must the low pressure spigot be removed from the steering pump.
Disconnect the low pressure line from the power steering pump.
Release the clip.
Loosen and release the power steering pump line.
12 .
Disconnect the pressure lines from the power steering gear.
Remove the bolt.
Position an absorbent cloth to collect fluid spillage.
Remove and discard the O-ring seals.
