LR3/Disco 3
Installation
1 .
Install the PCV valve.
Clean the component mating faces.
Install a new O-ring seal.
Tighten the bolts to 6 Nm (4 lb.ft).
2 .
Install new valve cover plug aperture seals
3 .
Install a new valve cover gasket.
4 .
NOTE :
Apply two beads of silcone gasket sealant as shown on the illustration. The application of the sealant
must be 3mm diameter 12mm long. Install the valve cover immediately after applying the sealant.
The cover should be fitted directly to the head without smearing the sealant or the seals.
Install the valve cover.
Clean the component mating faces.
5 .
Install the valve cover retaining bolts.
Install valve cover retaining bolts to their position previously noted.
Tighten the bolts to 12 Nm (9 lb.ft).
Complete the tightening sequence as illustrated.
