LR3/Disco 3
Installation
1 .
CAUTION: A new camshaft front seal is supplied with a transit sleeve that must not be removed
until the camshaft front seal is fully installed. Failure to follow this instruction may result in damage to
the vehicle.
CAUTION: Do not use any lubricant on the camshaft front seal, transit sleeve or the camshaft.
Failure to follow this instruction may result in damage to the vehicle.
CAUTION: Make sure the seal is installed correctly.
Using the special tool, install the camshaft front seal.
Clean the component mating faces.
Use the discarded camshaft pulley hub retaining bolt with the special tool.
Remove and discard the transit sleeve.
2 .
Using the special tool, install the camshaft pulley hub.
Install a new retaining bolt.
Tighten the retaining bolt in two stages:
Stage one: Tighten to 80 Nm (59 lb.ft).
Stage two: Tighten a further 90 degrees.
3 .
Install the camshaft pulley.
Install the bolts, but do not tighten fully at this stage.