LR3/Disco 3
Engine Mount LH (12.45.11)
Removal
Installation
Published : Aug 2, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the turbocharger. For additional information, refer to
Turbocharger (19.42.01)
(Section 303-
04)
3 .
CAUTION: Protect the engine during this operation.
Support the engine.
Raise the engine clear of its LH mount.
4 .
Remove the engine mount.
Remove the retaining nut.
Raise the engine clear of its LH mount.
Remove and discard the two retaining bolts.
1 .
Install the engine mount.
Clean the component mating faces.
Install new retaining bolts.
Tighten the bolts to 45 Nm (33 lb.ft), then a further 60 degrees.
2 .
CAUTION: Protect the engine during this operation.
Lower the engine onto its mount.
3 .
Install the engine mount retaining nut.
Tighten the nut to 90 Nm (66 lb.ft).