LR3/Disco 3
Installation
7 .
Remove the engine mount.
Remove and discard the two retaining bolts.
1 .
Install the engine mount.
Clean the component mating faces.
Install new retaining bolts.
Tighten the two new bolts to 45 Nm (33 lb.ft), then a further 60 degrees.
2 .
Install the engine mount bracket.
Clean the component mating faces.
Tighten the four retaining bolts to 80 Nm (59 lb.ft).
3 .
Attach the engine mounting bracket.
Lower the engine onto its mount.
Tighten the nut to 90 Nm (66 lb.ft).
4 .
Connect the ground cable.
Install the retaining bolt.
5 .
Install the generator. For additional information, refer to
Generator (86.10.02)
(Section 414-02)
6 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)