LR3/Disco 3
Installation
1 .
Tighten the LH exhaust manifold retaining studs to 13 Nm (10 lb.ft).
Install a new gasket.
2 .
NOTE :
Tighten the retaining nuts in the sequence shown.
Install the LH exhaust manifold.
Tighten the nuts to 24 Nm (18 lb.ft).
3 .
Install the three exhaust cross-over pipe retaining nuts.
Tighten the nuts to 24 Nm (18 lb.ft).
4 .
Install the LH exhaust manifold heat shield.
Install the two retaining bolts and tighten to 10 Nm (7 lb.ft).
5 .
Install the LH EGR valve.
Install the three EGR valve retaining bolts, but do not fully tighten at this stage.
6 .
NOTE :
Do not fully close the retaining clip at this stage.
Install the LH EGR valve inlet tube.
Install a new retaining clip.
Install a new gasket.
Loosely install the two EGR valve inlet tube retaining bolts.
7 .
Fully close the retaining clip.
8 .
Tighten the two EGR valve inlet tube retaining bolts to 10 Nm (7 lb.ft).
9 .
Tighten the three EGR valve retaining bolts to 10 Nm (7 lb.ft).
10 .
Install the support bracket.
Tighten the two retaining bolts to 10 Nm (7 lb.ft).
11 .
Connect the coolant inlet hose to the LH EGR valve.