LR3/Disco 3
Vehicles with automatic transmission
Vehicles with manual transmission
3 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
4 .
Remove the starter motor. For additional information, refer to
Starter Motor (86.60.01)
(Section 303-
06)
5 .
Remove the crankshaft timing alignment grommet from the engine block.
6 .
Rotate the crankshaft clockwise to align the crankshaft alignment hole in the flywheel or flexplate
with the block aperture.
7 .
Check the camshaft pulley alignment holes are correctly aligned. If the alignment holes are not
aligned, rotate the crankshaft one full turn clockwise.
1 .
Using the special tool, lock the flexplate.
Install a starter motor bolt to retain the special tool.
1 .
Using the special tool, lock the flywheel.
Install a starter motor bolt to retain the special tool.