LR3/Disco 3
10 . Remove the container.
11 . Connect and secure the radiator lower hose.
12 . Connect the battery ground cable.
13 . Connect exhaust extraction hoses to the tail pipes.
14 . Loosen the coolant expansion tank bleed screw.
15 . Fill the cooling system, keeping coolant to the upper level mark of the expansion tank.
16 . Tighten the bleed screw.
17 . Install the coolant expansion tank cap.
18 . Start and run the engine at idle until the normal operating temperature is reached.
19 .
NOTE :
Switch the engine off.
Secure with the clip.
WARNING: Release the cooling system pressure by slowly turning the coolant expansion tank cap a
quarter of a turn. Cover the expansion tank cap with a thick cloth to prevent the possibility of scalding. Failure
to follow this instruction may result in personal injury.
When the coolant bleed is complete and prior to installing the expansion tank cap, top-up the expansion tank to
30mm above the maximum level.
