LR3/Disco 3
4 .
Install the fuel temperature sensor.
Apply sealant to the sensor thread.
5 .
Install the fuel rail.
Install fuel injector O-ring seals.
Lubricate the O-ring seals with clean engine oil.
Tighten the Torx bolts to 10 Nm (7 lb.ft).
6 .
Connect the fuel temperature sensor electrical connector.
7 .
Connect the fuel injector electrical connectors.
8 .
Connect the engine wiring harness to the intake manifold.
9 .
Install the engine wiring harness support bracket.
Tighten the bolts to 10 Nm (7 lb.ft).
10 .
Connect the fuel line to the fuel rail.
Clean the component mating faces.
Position the fuel pipe into clips.
11 .
Install the evaporative loss valve assembly to the intake manifold bracket and connect the hose.
Clean the component mating faces.
12 .
Connect the crankcase vent hoses.
Clean the component mating faces.
13 .
Install the engine cover mounting brackets.
Tighten the nuts to 6 Nm (4 lb.ft).
Attach the wiring harness connector blocks to the brackets.
14 .
Install the engine cover. For additional information, refer to
Engine Cover - 4.4L (12.30.50)
(Section
501-05)
15 .
Connect the battery ground cable.