LR3/Disco 3
system components. Failure to follow this instruction may result in foreign matter ingress to the fuel injection
system.
CAUTION: Diesel fuel injection equipment is manufactured to very precise tolerances and fine
clearances. It is therefore essential that absolute cleanliness is observed when working with these components.
Always install blanking plugs to any open orifices or lines. Failure to follow this instruction may result in foreign
matter ingress to the fuel injection system.
CAUTION: Do not disassemble or clean inside the fuel pump, even with an ultrasonic cleaner. Always
install a new fuel pump when required.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the crankcase vent oil separator. For additional information, refer to
Crankcase Vent Oil
Separator (17.10.04)
(Section 303-08)
3 .
Remove the fuel injection pump belt cover.
Reposition the fuel charging wiring harness to allow access to the fuel injection pump belt
cover.
4 .
NOTE :
The fuel injection pump belt is not timed to the engine.
Remove and discard the fuel injection pump belt tensioner.
Remove the retaining bolt.