LR3/Disco 3
Installation
Using the special tool, remove the fuel injection pump pulley retaining nut.
14 .
Using the special tool, remove the fuel injection pump pulley.
1 .
Using the special tool, install the fuel injection pump pulley.
Tighten to 50 Nm (37 lb.ft).
2 .
Install the fuel injection pump.
Tighten the bolts to 23 Nm (17 lb.ft).
3 .
Install the fuel injection diverter rail.
Install the fuel injection diverter rail retaining studs, but do not fully tighten at this stage.
4 .
Attach the fuel charging wiring harness.
Install the retaining nut.
5 .
Install the new high-pressure fuel supply lines.