LR3/Disco 3
Accessory Drive Belt Idler Pulley (86.10.23)
Removal
Installation
Published : May 6, 2004
1 .
Disconnect the battery ground cable.
2 .
Remove the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
3 .
Remove the accessory drive belt idler.
Remove the bolt.
Remove and discard the seal.
4 .
Remove the accessory drive belt idler pulley.
Remove the bolt cover.
Remove the Torx bolt.
1 .
Install the accessory drive belt idler pulley.
Clean the components.
Tighten the Torx bolt to 25 Nm (18 lb.ft).
Install the bolt cover.
2 .
Install the accessory drive belt idler.