LR3/Disco 3
Exhaust Gas Recirculation (EGR) Valve (17.45.01)
Removal
Installation
Published : May 17, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00 Charging System - General Information)
2 .
Disconnect the EGR valve electrical connector.
3 .
Release the clips and disconnect the hoses from the EGR valve cooler.
Position an absorbent cloth to collect fluid spillage.
Clamp the EGR coolant hoses to minimize coolant loss.
4 .
Remove the EGR valve.
Remove the 2 bolts from the EGR cooler valve body.
1 .
To install, reverse the removal procedure.
Clean the component mating faces.
Tighten the bolts to 10 Nm (7 lb.ft).
2 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00
Charging System - General Information)
3 .
Check and top up the coolant.