LR3/Disco 3
Evaporative Emission Canister Purge Valve (17.15.39)
Removal
Installation
Published : Aug 23, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the intake manifold casting. For additional information, refer to
Intake Manifold (30.15.02)
(Section 303-01)
3 .
NOTE :
Note the fitted position.
Release the purge valve from the mounting bracket.
Remove the bolt.
4 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
Remove the purge valve.
Disconnect the 2 hoses.
Disconnect the electrical connector.
1 .
Connect the purge valve.
Connect the hoses.
Connect and secure the electrical connector.
2 .
NOTE :
Align to the position noted on removal.
Install the purge valve, align the peg and tighten the bolt to 6 Nm (4 lb.ft).
3 .
Install the intake manifold casting. For additional information, refer to
Intake Manifold (30.15.02)
(Section 303-01)