Removal and Installation of Crankshaft Position Sensor for LR3/Disco 3
Crankshaft Position (CKP) Sensor (18.30.12)
Removal
Installation
Published : May 21, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
Remove the engine undershield. For additional information, refer to
Engine Undershield (76.10.50)
(Section 501-02)
4 .
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
Remove the CKP sensor.
Disconnect the electrical connector.
Remove the Torx screw.
1 .
To install, reverse the removal procedure.
Tighten the Torx screw to 8 Nm (6 lb.ft).