LR3/Disco 3
Engine Control Module (ECM) (18.30.03)
Removal
NOTE :
Installation
Published : Jun 10, 2004
If the ECM is to be replaced, the T4 must be connected prior to battery disconnection and on-screen instructions
must be followed.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the four-wheel drive control module. For additional information, refer to
Four-Wheel Drive
(4WD) Control Module (41.30.01)
(Section 308-07)
3 .
Remove the ECM cover.
Disconnect 2 electrical connectors for access.
Disconnect the 2 ECM electrical connectors.
Remove the 4 Torx screws.
4 .
Remove the ECM.
Remove the ECM top cover.
1 .
Install the ECM.
Install the ECM cover and secure with Torx screws.
Install the ECM upper cover.