LR3/Disco 3
Manifold Absolute Pressure (MAP) Sensor (18.30.56)
Removal
Installation
Published : May 18, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the engine cover. For additional information, refer to
Engine Cover - 4.4L (12.30.50)
(Section 501-05)
3 .
Remove the manifold absolute pressure (MAP) sensor.
Disconnect the electrical connector.
Remove the 2 Torx screws.
1 .
To install, reverse the removal procedure.
Clean the component mating faces.