LR3/Disco 3
Oil Temperature Sensor (12.60.65)
Removal
Installation
Published : Jul 13, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the radiator access panel.
Remove the 4 bolts.
3 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
Remove the oil temperature sensor.
Disconnect the electrical connector.
Position a container to collect the fluid.
1 .
To install, reverse the removal procedure.
Tighten the oil temperature sensor to 20 Nm (15 lb.ft).
Tighten the bolts to 10 Nm (7 lb.ft).
2 .
Check and top-up the engine oil.