LR3/Disco 3
1 .
Install the fluid pan.
Clean the components.
Install the seal.
Install a new O-ring seal.
Tighten the Torx screws to 8 Nm (6 lb.ft).
2 .
Lower the RH side of engine.
Remove the engine support.
Tighten the bolts to 45 Nm (33 lb.ft).
3 .
Install the transmission heat shield bracket.
Tighten the 4 bolts to 10 Nm (7 lb.ft).
Connect the selector cable to its abutment bracket.
4 .
Install the transmission heat shield.
Tighten the bolts to 10 Nm (7 lb.ft).
5 .
Install the exhaust system. For additional information, refer to
Exhaust System (30.10.08)
(Section
309-00)
6 .
Install the battery compartment side wall. For additional information, refer to
Battery Tray (76.10.30)
(Section 414-01)
7 .
Refill the transmision with fluid. For additional information, refer to (Section 307-01B )