LR3/Disco 3
Installation
22 .
Remove the selector lever.
Remove the nut.
1 .
Attach the selector lever.
Tighten the nut to 12 Nm (9 lb.ft).
2 .
Attach the transmission breather lines.
Secure with the clip.
3 .
Attach the selector cable bracket.
Tighten the bolts to 10 Nm (7 lb.ft).
4 .
Attach the wiring harness bracket.
Tighten the Torx bolt to 10 Nm (7 lb.ft).
Repeat the above procedure for the other side.
5 .
Using the special tool, install a new torque converter oil seal.
Clean the seal register.