LR3/Disco 3
Install the new O-ring seals.
Secure with the clip.
Tighten the bolt to 10 Nm (7 lb.ft).
16 .
Install the fuel pipe heat shield.
Tighten the bolts to 10 Nm (7 lb.ft).
Secure with the clips.
17 .
Install the transmission heat shield bracket.
Tighten the bolts to 10 Nm (7 lb.ft).
18 .
NOTE :
Do not tighten the locking nut at this stage.
Connect the selector cable to the transmission.
Engage the inner cable with the lever clamping bush.
Install the selector cable to its abutment bracket.
19 .
Install the transfer case. For additional information, refer to
Transfer Case - 4.4L (41.20.25.99)
(Section 308-07)
20 .
Adjust the selector cable. For additional information, refer to
Selector Lever Cable Adjustment
(44.30.04)
(Section 307-05)
21 .
Check and top-up the transmission fluid level. For additional information, refer to
Transmission
Fluid Level Check (44.24.06)
(Section 307-01)
22 .
Install the transmission heat shield.
Tighten the bolts to 10 Nm (7 lb.ft).