LR3/Disco 3
6 .
Check for correct cable adjustment.
7 . If installed, install the transmission heat shield.
8 . Install the transmission undershield.
Move the selector lever on the gearbox fully forward and release it. The lever will return to the 'P' position.
Make sure the selector lever is in the 'P' position.
Push the cable inner rearward then release it.
Tighten the locknut to 10 Nm (7 lb.ft).
WARNING: The hand brake and foot brake MUST BE applied.
Move the selector lever from 'P' position, check engagement in each position and return to 'P'.
Check that the engine will start in 'P' and 'N' positions and that the engine start is inhibited when drive positions
are selected.
Tighten the bolts to 10 Nm (7 lb.ft).
Tighten the bolts to 10 Nm (7 lb.ft).
