LR3/Disco 3
Pilot Bearing (12.21.45)
Special Service Tools
Pilot (spigot) bearing installer/clutch alignment
303-1096
Removal
Installation
Published : May 11, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the flywheel. For additional information, refer to
Flywheel (12.53.07)
(Section 303-01)
3 .
Remove the pilot bearing.
With the flywheel supported, use a drift.
1 .
Using the special tool, install the pilot bearing.
Clean the component mating faces.