LR3/Disco 3
Installation
5 .
Remove the clutch master cylinder.
Disconnect the fluid supply line and discard the O-ring seal.
1 .
Install the clutch master cylinder.
Using a new seal, connect the fluid supply line.
Install the clip.
Tighten the bolts to 10 Nm (7 lb.ft).
Connect the electrical connector.
Remove the container.
2 .
Install the clutch pedal spring assister.
3 .
Secure the clevis pin.
Fit the clip.
4 .
Install the closing trim panel.
Connect the electrical connector.
Secure the clip.
Tighten the screws.