LR3/Disco 3
Transfer Case Clutch Solenoid (41.30.08)
Removal
Installation
Published : Jul 19, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
CAUTION: Connect T4, prior to removal of the solenoid.
NOTE :
Some fluid spillage is inevitable during this operation.
Remove the transfer case clutch control solenoid.
Position a container to collect the fluid spillage.
Remove the 3 Torx screws.
Use T4 to energise the solenoid.
Detach from the selector lever.
Disconnect the electrical connector.
1 .
CAUTION: Make sure the seal is installed correctly.
Install the transfer case clutch control solenoid.
Clean the components.
Connect the electrical connector.
Use T4 to energise the solenoid.
Install to the selector lever.
Tighten the Torx screws to 10 Nm (7 lb.ft).
