LR3/Disco 3
Tailpipe (30.10.22)
Special Service Tools
Pipe cutter-exhaust
100-051 (LRT-99-027)
Removal
Installation
Published : May 10, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the tail pipe.
Using 100-051, cut the tail pipe at the point indicated by a depression in the pipe.
Disconnect from the exhaust hanger.
1 .
NOTE :
Do not tighten the retaining clamp at this stage.
Install the tail pipe.
Clean the components.
Install the retaining clamp.
2 .
Align the tail pipe and tighten the retaining clamp to 55 Nm (40 lb.ft).