LR3/Disco 3
Fuel Tank Filler Pipe (19.55.07)
Removal
Published : Jun 21, 2004
WARNING: Do not carry or operate cellular phones when working on or near any fuel related
components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions
may result in personal injury.
WARNING: The spilling of fuel is unavoidable during this operation. Ensure that all necessary
precautions are taken to prevent fire and explosion.
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Position the vehicle on a lift.
2 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
3 .
Drain the fuel tank. For additional information, refer to
Fuel Tank Draining (19.55.02)
(Section 310-
00)
4 .
Remove the RH rear wheel and tire.
5 .
Remove the fender moulding. For additional information, refer to
Rear Quarter Panel Moulding
(76.43.55)
(Section 501-08)
6 .
Remove the fender splash shield.
Remove the 2 screws.
Remove the 6 retainers.
Disconnect the electrical connector.