LR3/Disco 3
Installation
12 .
Remove the A/C compressor.
1 .
Position the A/C compressor to the engine.
If a new compressor is being installed, the required amount of refrigerant oil must be
drained from it.
2 .
Install the A/C compressor mounting bracket.
Tighten the bolts to 25 Nm (18 lb.ft).
3 .
Secure the A/C compressor.
Tighten the bolts to 25 Nm (18 lb.ft).
4 .
Connect the A/C clutch electrical connector.
5 .
CAUTION: Lubricate the new seals with clean refrigerant oil.
Connect the refrigerant lines.
Clean the component mating faces.
Install the new O-ring seals.
Tighten the bolts to 10 Nm (7 lb.ft).
6 .
Install the front wheel.
Tighten the wheel nuts to 140 Nm (103 lb.ft).
7 .
Lower the vehicle.
8 .
Install the oil level indicator and tube. For additional information, refer to (Section 303-01)
9 .
Install the accessory drive belt tensioner.