LR3/Disco 3
Installation
1 .
Install the new A/C compressor.
If a new compressor is being installed, drain the required amount of refigerant oil from the
new compressor.
Tighten the bolts to 25 Nm (18 lb.ft).
2 .
Connect the A/C clutch electrical connector.
3 .
Connect the refrigerant lines.
Clean the component mating faces.
Install the new O-ring seals.
Tighten the bolts to 10 Nm (7 lb.ft).
4 .
Install the engine compartment upper LH heat shield.
5 .
Install the power steering pump mounting bracket.
Clean the component mating faces.
Tighten the bolts to 25 Nm (18 lb.ft).
6 .
Install the power steering pump. For additional information, refer to
Power Steering Pump - 4.4L
(57.20.14)
(Section 211-02)
7 .
Secure the transmission cooler pipes into clips.
8 .
Install the fender splash shield. For additional information, refer to
Fender Splash Shield (76.10.48)
(Section 501-02)
9 .
Install the splash shield.
10 .
Install the front wheel.
Tighten the nuts to 115 Nm (85 lb.ft).
11 .
Lower the vehicle.
12 .
Fill the A/C system. For additional information, refer to
Air Conditioning (A/C) System Recovery,