LR3/Disco 3
Driver Side Temperature Blend Door Actuator (80.10.37)
Removal
Installation
Published : Jun 26, 2004
1 .
Remove the instrument panel driver side reinforcement. For additional information, refer
to
Instrument Panel Driver Side Reinforcement (76.46.31)
(Section 501-12)
2 .
Remove the driver side footwell duct.
Remove the 2 Torx screws.
3 .
Remove the temperature blend door actuator.
Disconnect the electrical connector.
Remove the 2 screws.
1 .
Install the temperature blend door actuator.
Tighten the screws.
Connect the electrical connector.
2 .
Install the driver side footwell duct.
Tighten the screws.