LR3/Disco 3
Instrument Panel Blend Door Actuator - LHD (80.20.09)
Removal
Installation
Published : Jun 26, 2004
1 .
Remove the instrument panel driver side reinforcement. For additional information, refer
to
Instrument Panel Driver Side Reinforcement (76.46.31)
(Section 501-12)
2 .
Remove the driver side footwell duct.
Remove the 2 Torx screws.
3 .
Remove the instrument panel blend door actuator.
Disconnect the electrical connector.
Remove the 2 screws.
1 .
Install the instrument panel blend door actuator.
Tighten the screws.
Connect the electrical connector.
2 .
Install the driver side footwell duct.
Tighten the screws.
3 .
Install the instrument panel driver side reinforcement. For additional information, refer to
Instrument
Panel Driver Side Reinforcement (76.46.31)
(Section 501-12)