LR3/Disco 3
Installation
5 .
Remove the temperature blend door actuator.
Disconnect the electrical connector.
Remove the 2 screws.
1 .
Install the temperature blend door actuator.
Tighten the screws.
Connect the electrical connector.
2 .
Install the passenger side footwell duct elbow.
Tighten the screws.
3 .
Install the passenger side footwell duct.
Install the clip.
4 .
Install the passenger side closing trim panel.
Install the interior lamp.
Connect the electrical connector.
Secure the clip.
5 .
Install the glove compartment. For additional information, refer to
Instrument Panel Console
(76.25.03)
(Section 501-12)