LR3/Disco 3
Generator (86.10.02)
Removal
Installation
Published : Jun 24, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
3 .
Disconnect the generator electrical connectors.
Release the gaiter, remove the nut and disconnect the cable.
Disconnect the electrical connector.
4 .
Remove the generator.
Remove the 3 bolts.
1 .
CAUTION: Tighten the bolts in the sequence shown.
Install the generator.
Clean the component mating faces.
Tighten the bolts to 45 Nm (33 lb.ft).