LR3/Disco 3
Hood Switch (86.77.20)
Removal
Installation
Published : Mar 3, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Release the RH hood latch.
Remove the 2 Torx bolts.
Disconnect the electrical connector.
3 .
Remove the hood switch.
1 .
Install the hood switch.
2 .
Install the RH hood latch.
Connect the electrical connector.
Tighten the Torx bolts to 10 Nm (7 lb.ft).
3 .
Open and close the hood to check the hood latch operation.
4 .
Adjust the hood latch.
Loosen the 2 hood latch Torx bolts.
Lower the hood and check for alignment.
Open the hood and tighten the Torx bolts to 10 Nm (7 lb.ft).
Check for the correct operation of the hood safety catch.
If necessary, repeat the above adjustment procedure.
