LR3/Disco 3
Navigation System Display Module (86.53.20)
Removal
Installation
Published : Jun 15, 2004
1 .
CAUTION: After switching of the ignition, wait for 2 minutes before disconnecting the battery.
Failure to wait for 2 minutes will damage the navigation computer.
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the instrument panel console. For additional information, refer to
Instrument Panel Console
(76.25.03)
(Section 501-12)
3 .
CAUTION: Cover fibre optic cable connectors to minimise dust ingress and avoid bending the
cables in a radius of less than 30 mm.
Remove the navigation system display module.
Remove the 4 Torx screws.
Disconnect the fibre optic connector.
Disconnect the 2 electrical connectors.
1 .
Install the navigation system display module.
Connect the electrical connectors.